Chasing and Repousse Tools

Chasing and Repousse is the art of shaping metal into dimensional shapes with small chisels with a wide range of working end designs. The twisted ends of the tools are hit with a chasing hammer, while the working ends are held in position with the holding hand.

The sheet metal is usually held in pitch as chasing tools strike the metal. The metal is pushed down and forms or designs will emerge as the process continues. Chasing usually refers to the metal being worked from the top side while the term repousse indicated the metal is worked from both sides.

Items 1 to 10 of 12 total

per page
Page:
  1. 1
  2. 2

Set Descending Direction
  1. HMR-17 Chasing hammer
  2. HMR-20 Classic Chasing Hammer-Heavy
  3. HMR-20M  Classic Chasing Hammer-Medium
  4. HMR-417 Precisionsmith Chasing Hammer
  5. E Set    Embossing Repousse Set
  6. PL Set      Planishing Repousse Set
  7. RF-101 thru RF-106- Large Repousse- Fluting Set
  8. RF-1 thru RF-4 - Small Repousse- Fluting Set
  9. RH Holder Without Insert Ends
  10. RH Holder Deluxe and  7 Insert End

Items 1 to 10 of 12 total

per page
Page:
  1. 1
  2. 2

Set Descending Direction